Handle with built-in anti-slip base
User manual
Place the spring plate on the centrifugal plate
Turn the knob (3) until it touches
knob (2), make sure the adjusting screw is fixed, loosen
knob (1) and place it on the knob (2). Insert the device into the center of the gear plate, pierce the spring plate and press down.
Hold knob (2) in place, knob (1) taper block
expansion in the middle of the clutch disc.
Tighten the knob (3) until it touches the spring plate
but don't block the knob.
Center the disc manually on the spring plate.
Hold the tilt assembly, tighten knob (3)
into the spring plate.
Place the centrifugal on the flywheel of the motor and fix it.
Loosen the knob (3), fully loosen the knob
(1) and press down to release the expansion cone. Remove the tool from the clutch.